|
|
|
|
|
Dually Cube Gallery!
(Click on any of the smaller images for a full size picture)
--------------------------------------------------------------------------------------------
Specs
Hardware
2x Athlon XP 1800+ @ 144FSB
MSI K7D Master-L Motherboard
1024MB Crucial Registered PC2100 DDR-RAM
AMI MegaRAID Elite 1600 Dual-Channel SCSI RAID Controller
ATI All-in-Wonder Radeon 9700 Pro
Turtle Beach Santa Cruz Sound Card
PCI IEEE-1394 Firewire Card
Storage Subsystem
2x Seagate 18.4GB x15 Cheetah drives in RAID0 stripe (OS)
Western Digital 120GB WD1200BB 7200rpm (FTP)
Maxtor 160GB 7200rpm (external via firewire)
Seagate 40GB 7200rpm (Backup)
Yamaha CRW-F1 CD-RW (black)
Sony 4x DVD+/-RW
Cooling
2x DangerDen Maze2 Waterblocks
DangerDen Z-Chip Waterblock for Chipset
DangerDen Radeon Video Card Waterblock
DangerDen Super Cube copper radiator
Sunon 120mm 2400rpm 69cfm fan
Hydor L30 320GPH Pump
DangerDen Dual Reservoir (fills two 3.5 drive bays)
8ft (approx) 1/2" ID Tygon tubing
--------------------------------------------------------------------------------------------
Feb 17, 2004 Update
It's been a long time since I've updated this page! Since the last update, I've added video and chipset waterblocks, installed a better pump to accommodate for the extra blocks, ditched the self-contained reservoir setup and switched to Tygon tubing. My reservoir is now a clear plexiglass setup that takes two 2.5" drive bays.
Here are some updated pictures (the old ones are still below):
|
|
|
|
|
Before you say anything, I'm working on the "kink" in the last photo. I just need to install a 45-degree fitting, which I didn't have on hand at the time I put it all together. I'll try and do some more updating later...
--------------------------------------------------------------------------------------------
New Pictures! - I just changed from the Gigabyte board to an MSI K7D Master-L.
--------------------------------------------------------------------------------------------
I purchased the window kits from CaseMods.com for a small fee. I really wanted the AMD logo, but couldn't find a pre-etched window or even an appliqué, so I decided to mask off the logo using electrical tape, and sandblast it myself! I think it turned out pretty slick.
-----------------------------------------------------------------------------------
Here are some exterior shots of the Cube on the outside
-----------------------------------------------------------------------------------
Taking a look inside the beast!
-----------------------------------------------------------------------------------
Don't forget to turn out the lights!
-----------------------------------------------------------------------------------
Temperatures
-----------------------------------------------------------------------------------
The case is a YY0221 made my YeongYang. You can check out the specs here:
-----------------------------------------------------------------------------------